Common faults of froth pump

• 10  Mar, 2023

Today we will take a look at the froth pump will encounter what kind of problems, encounter these problems, we should do?

First of all, one of our common problems is that the shaft power of the froth pump is too large, which will cause friction in the foam pump, misalignment or imbalance between the motor shaft and the pump shaft, which will also lead to bearing damage, excessive flow of the froht pump, and too tight belt of the driving device.

At this time, the corresponding solution is to eliminate friction, adjust the motor shaft and pump shaft, replace the new bearing, adjust the running condition of the foam pump, adjust the belt, so that the above problems will be solved.

froth pump also often encounter the problem is that the bearing of the froht pump is overheating, the bearing is easy to damage, replace the new bearing, the bearing grease of the froth pump is too much or too little, add grease to be appropriate, there is debris in the grease, replace the new grease.

The bearing life of the froth pump is too short, the motor end and the pump shaft are not aligned or uneven phenomenon occurs, the motor shaft and the pump shaft can be adjusted, the shaft of the froth pump is bent, it is necessary to replace the new pump shaft, the friction in the froth pump or the impeller is out of balance, we need to eliminate the friction, and then replace the new impeller. When there are foreign bodies in the bearing of the froth pump or improper grease, we can clean the shaft.